Preparing the Rack
Mount the brackets and rail assemblies on the rack.Mounting the Brackets
Mount the brackets that hold the rail assemblies in place on the rack.1 Decide where the brackets are to be mounted. The library position in relation to the bracket position is explained below.
We recommend using a marker to mark the position where each bracket is to be mounted.
Caution
Note that if the four brackets are not mounted at the correct height, it will be impossible to mount the library.
1U
2U
2U
2 Using the bracket positioning and B screws, mount the two front brackets on the rack.
1Insert a bracket positioning screw into the second screw hole from the top of the bracket and tighten it slightly.
2Insert a B screw into the second screw hole from the bottom of the bracket and tighten it slightly. Align the screws with the center of the rack screw holes, and then tighten the screws completely, securing the bracket to the rack.
Caution
Use the bracket positioning screws only with the upper part of the screw holes on the front brackets.
Bracket
Bracket positioning screw
B screw
| Bracket positioning screw |
| Make sure that the bracket screw |
2U | holes are centered horizontally. |
|
Position of screw cramps
Center the |
|
screw holes | Bracket |
|
3 Using the B screws and rack mounting spacers, mount the two rear brackets on the rack.
First align the rack mounting spacers with the upper part of the rack screw holes, then center the B screws on the rack screw holes, and finally secure the brackets to the rack.
Make sure that all four brackets are facing the correct way and are mounted at the correct height.
Caution
Only use the spacers with the upper screws on the rear brackets. (The spacers are only used with the rear brackets.)
Rack mounting spacer
B screw
B screw
12 Preparation