Manual Programming Functions
Press the keys on the keypad as shown in the following steps. Wait for the confirmation indicator before proceeding to the next step. If you make a mistake, wait for all lights and beeps to stop and then start over from the beginning.
Add
Delete
Change
EnableVacation
Mode
(Disable All)
Enable/Disable
Beeper
Delete All2
Enable/Disable3 Turn Lock Feature
Put Lock in
Enrollment Mode4
Press (Six
Numbers)
Wait For
3 Lights + 3 Beeps
Press (Six
Numbers)
Wait For
3 Lights + 3 Beeps
Press (Six
Numbers) Wait For
3 Lights + 3 Beeps
Press
(Six
Numbers)
Wait For
3 Lights + 3 Beeps
Press
(Six
Numbers)
Wait For
3 Lights + 3 Beeps
Press
(Six
Numbers)
Wait For
3 Lights + 3 Beeps
Press
(Six
Numbers)
Wait For
3 Lights + 3 Beeps
Press
(Six
Numbers)
Wait For
3 Lights + 3 Beeps
Press
Wait For
3 Lights + 3 Beeps
Press
Wait For
3 Lights + 3 Beeps
Press
Wait For
3 Lights + 3 Beeps
Press
Success!
1 Long Light + 1 Long Beep
Press
Success!
1 Long Light + 1 Long Beep
Press
Wait For
3 Lights + 3 Beeps
Press
Success!
1 Long Light + 1 Long Beep
Press
Success!
Blinking
Press New (Four
Numbers)
Wait For
3 Lights + 3 Beeps
Press Unwanted (Four
Numbers)
Wait For
3 Lights + 3 Beeps
Press New (Six
Numbers)
Wait For
3 Lights + 3 Beeps
DisableVacation
Mode
(Enable All1)
Press
(Six
Numbers)
Success!
1 Long Light + 1 Long Beep
Press Same New (Four
Numbers)
Success!
1 Long Light + 1 Long Beep
Press Same Unwanted
(Four
Numbers)
Success!
1 Long Light + 1 Long Beep
Press Same New
(Six
Numbers)
Success!
1 Long Light + 1 Long Beep
Press
(Six
Numbers)
Success!
1 Long Light + 1 Long Beep
1Enable All User Codes function is available only when user codes are currently disabled.
2Delete All User Codes function will remove ALL user codes, but will not change the programming code. User Codes cannot be recovered after this function is completed.
3The Turn Lock Feature is available only on the BE369 (deadbolt). When this feature is disabled, a valid user code must be entered in order to lock the lock from the outside. The Turn Lock feature is enabled by default.
4Bridge must be put into enrollment mode before lock for successful enrollment/exclusion.
5
