When PICTURE MODE is set to any of User1, User2 and User3, you can adjust the following items.
Refer to the Operating Instructions for the FWD series as well.
Contrast +/– buttonsAdjusts the picture contrast.
Brightness +/– buttonsAdjusts the picture brightness.
Chroma +/– buttonsAdjusts color intensity.
Phase +/– buttonsAdjusts color tones.
Setup windowA dialog box prompting you to enter a Network Password appears. “Name: root” is preset as the factory setting without a password.
The settings entered or changed in each window become valid after you click Apply located near the bottom of the window. You cannot enter special characters in this window.
Owner InformationOwnerEnter information on the owner.
Display LocationEnter the location of the Display unit.
MemoYou can write comments or notes here.
TimeTimeEnter the current time and the day of the week.*
*For the
Under normal circumstances, set this item to “Obtain an IP address automatically (DHCP).” Enter the required value (address) if you set it to “Specify an IP address.”
PasswordNames and Passwords can be set individually for the Administrator and each User. The Name for the Administrator is permanently set to “root.”
Mail Report*If an error occurs inside the Display unit, the system immediately reports the error by sending an
* Except for the
Enter an
Mail Address:
Enter the
The maximum number of characters of the address is 64.
Outgoing Mail Server (SMTP) (SMTP server):
Enter the address of the SMTP server. The maximum number of characters of the address is 64.
Requires the use of POP Authentication before Send
Check the “POP before SMTP” check box when POP authentication is needed before connecting to the SMTP server.
Ingoing Mail Server (POP3):
Enter the address of the POP3 server to be used for POP Authentication (POP before SMTP).
Operations from a Computer 11GB