Close the cable holders.
Overview
Note
Be sure to power this unit off before proceeding to the following operation.
1 Remove the two screws and gently pull the SDI unit out.
Note
Be careful not to pull the SDI unit out too far. Doing so may disconnect or damage the connectors.
SD | I IN |
|
Screw
1
2
Screw
2 Open the cable holders of the SDI unit.
3 Change the connections for both cables as shown below.
Before changed (VBS mode)
After changed (SDI mode)
4
5 Repeat step 1 in reverse to return the SDI unit to its original position.
6 Open the cover of the setting switches on the front panel.
7 Set system setting switch 3 as shown below.
12