Location and Function of Parts

4OUTPUT switch

Use this switch to select the type of the signal to be output from the R/R-Y, G/Y, B/B-Y connectors or the S VIDEO connector.

R/G/B: The R, G, and B color signals are output from the R/R-Y, G/Y, and B/B-Y connectors, respectively. No signal is output from the S VIDEO connector at this time.

R-Y.Y.B-Y: The R-Y, Y, and B-Y component signals are output from the R/R-Y, G/Y, and B/B- Y connectors, respectively. No signal is output from the S VIDEO connector at this time.

S VIDEO: The S-video signal is output from the S VIDEO connector. No signals are output from the R/R-Y, G/Y, and B/B-Y connectors at this time.

5R/R-Y, G/Y, and B/B-Y (component video signal/RGB signal output) connectors (BNC type) Use these connectors to output the signals from the video camera as RGB color signals or component signals (R-Y,B-Y, and Y).

6MIC OUT (microphone output) connector (XLR 3-pin)

Use this connector to output microphone signal from the connected video camera.

7CAMERA connector (Z-type 26-pin)

Connect a camera cable here to connect this unit to the CA-537/537P Camera Adaptor attached to a video camera.

8AC IN connector

Use this connector to connect an AC power source via the supplied power cord.

9REMOTE (remote control unit) connector (10- pin)

Use this connector to connect the RM-M7G Remote Control Unit using a CCA-7 connecting cable (not supplied).

q; INTERCOM/TALLY terminals (screw terminals)

Use these terminals to connect an intercom system which cannot be connected to qa TALLY/ INTERCOM connector (DIN 4-pin).

qa TALLY/INTERCOM connector (DIN 4-pin)

Intercom signals and tally signals are input and output via this connector. Connect to the intercom system’s INTERCOM/TALLY connector using a CCDD-2.5 tally/intercom cable (not supplied).

qs S VIDEO (S-video signal output) connector (mini DIN 4-pin)

Use this connector to output S-video signal from the video camera.

qd SYNC OUT (sync signal output) connector (BNC-type)

This connector outputs the sync signal from the video camera.

qf MONITOR OUT (picture monitor output) connector (BNC-type)

Use this connector to output the composite video signal to a video monitor. When the MENU button on the front panel of this unit is pressed, information on the settings made in the AUX operations section of this unit can be added to the output signal.

qg RETURN VIDEO (return video signal) IN/OUT connectors (BNC type) and 75Ω termination switch The IN connector accepts the on-the-air signal or signal currently being recorded from a control console or a special effects generator, and the OUT connector supplies the same signal to the viewfinder of the camera. The IN and OUT connectors are loop-through connectors, with the signal input from the IN connector being directly output to the OUT connector. When no external device is connected to the OUT connector, the 75Ω termination switch should be set to ON.

Notes

•When the return video signal is input from the RETURN VIDEO IN connector, be sure to input the sync signal from the GENLOCK IN connector.

•The signal input from the RETURN VIDEO IN connector must be synchronized with the signal input from the GENLOCK IN connector. Otherwise, camera synchronization may be unstable.

14