When Using an RM-M7G Remote
Control Unit
When an RM-M7G Remote Control Unit is connected to the CCU-M5A/M5AP, you can control the video camera with the RM-R7G. The remote control unit can also be connected directly to the video camera. When this unit is turned on, the camera is controlled with the CCU-M5A/M5AP. To control the camera with the RM-M7G, do the procedure below:
1 Make the following preparations on the CCU- M5A/M5AP:
•Set the OUTPUT switch on the rear panel to the appropriate position according to the connected video equipment.
•Set the CABLE COMP selector according to the length of the cable.
2 Make the following preparations on the RM-M7G:
•Press the PANEL ACTIVE button.
•Set the CAMERA SELECT switch to “1.”
To control the camera with the CCU-M5A/ M5AP
Press the PANEL ACTIVE button on the CCU-M5A/ M5AP.
Notes
•The PANEL ACTIVE button on the RM-M7G may not function if you press it while you are operating this unit. In such a case, complete the operation first, then press the PANEL ACTIVE button.
•When the DXC-950 series Color Video Camera is used, the RM-M7G cannot be connected to this unit.