Troubleshooting guide
The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures.
General
| Problem | Cause/Solution |
|
|
| No sound. | • Cancel the ATT function. |
| • Set the fader control to the centre position for |
| systems. |
| • Rotate the dial in a clockwise direction to adjust the volume. |
| The contents of the memory | • The power cord or battery has been disconnected. |
| have been erased. | • The reset button has been pressed. |
| nStore again into the memory. |
Indications do not appear in the | Remove the front panel and clean the connectors. See “Cleaning |
| display. | the connectors” (page 26) for details. |
| No beep tone. | • An optional power amplifier is connected and you are not |
| using the |
| • The beep tone is attenuated (page 18). |
Problem | Cause/Solution |
|
|
| A disc cannot be loaded. | •Another CD is already loaded. |
| •The CD is forcibly inserted upside down or in the wrong way |
| (MD). |
| Playback does not begin. | Defective MD or dusty CD. |
| A disc is automatically ejected. | The ambient temperature exceeds 50°C. |
| The operation buttons do not | Press the reset button. |
| function. |
|
|
|
| The sound skips due to | • The unit is installed at an angle of more than 60°. |
| vibration. | • The unit is not installed in a sturdy part of the car. |
Problem | Cause/Solution |
| Preset tuning is not possible. | • Memorise the correct frequency. |
| • The broadcast signal is too weak. |
| Automatic tuning is not | The broadcast signal is too weak. |
| possible. | nUse manual tuning. |
| The “ST” indication flashes. | • Tune in the frequency accurately. |
| • The broadcast signal is too weak. |
| nSet to the MONO mode (page 11). |
EN
Information Additional
29