Adjusting the fader (FAD)
Normally, with the DSP mode on, the volume of the output sound from the rear speakers is lowered automatically to improve the efficiency of the listening position setting. If you want to raise the rear speaker volume, adjust the fader.
1 Follow steps 1 to 3 of “Selecting a surround menu” (page 18).
2 Press (SOUND) repeatedly until “FAD” appears.
3 Press (+) or (Ð) to adjust the fader.
| Increases front speaker volume |
| Decreases front speaker volume |
EN | After three seconds, the display goes back |
| to the normal playback mode. |
Adjusting the volume of the subwoofer(s)
1 Press (SOURCE) to select a source (radio,
CD or MD).
2 Press (SOUND) repeatedly until “SUB” appears.
3 Press (+) or (Ð) to adjust the volume. After three seconds, the display goes back to the normal playback mode.
Adjusting the frequency of the subwoofer(s)
To match the characteristics of the connected subwoofer(s), you can cut the unwanted high and middle frequency signals entering the subwoofer(s). By setting the
Level | |
|
|
62 125 198 | Frequency (Hz) |
1 Press (SOURCE) to select a source (radio,
CD or MD).
2 Press (SOUND) for two seconds.
3 Press (SOUND) repeatedly until “SUB” appears.
SUB
COFF 125
4 Press (+) or (Ð) to select the desired cut- off frequency.
The
5 Press (SOUND) for two seconds.
When the frequency setting is complete, the display goes back to the normal playback mode.
Adjusting the volume of the bass and treble
You can adjust the volume of the bass and treble to best fit the acoustic characteristics inside your car.
1 Press (SOURCE) to select a source (radio,
CD or MD).
2 Press (SOUND) repeatedly until “BAS” or “TRE” appears.
20
Actual total number: | Sony |
|
|
