Detaching the front panel
You can detach the front panel of this unit to protect the unit from being stolen.
1 Press OFF.
2 Press RELEASE to open the front panel, then slide the front panel to the left side, and pull out from the right side of the front panel.
OFF
Caution alarm
If you turn the ignition key switch to the OFF position without removing the front panel, the caution alarm will beep for a few seconds (only when the ACC Position is set to “yes”) (see page 4).
Notes
•Be sure not to attach the front panel upside down.
•Do not press the front panel hard against the unit when attaching it. Press it lightly against the unit.
•Do not press hard or put excessive pressure on the display windows of the front panel.
•Do not expose the front panel to direct sunlight or heat sources such as hot air ducts, and do not leave it in a humid place. Never leave it on the dashboard of a car parked in direct sunlight where there may be a considerable rise in temperature.
RELEASE
Notes
•Do not put anything on the inner surface of the front panel.
•Be sure not to drop the panel when detaching it from the unit.
•If you detach the panel while the unit is still on, the power will turn off automatically to prevent the speakers from being damaged.
•When you carry the front panel with you, put it in the supplied front panel case.
Attaching the front panel
Place the hole a on the front panel onto the spindle b on the unit as illustrated, then push the left side in.
a
b
Detaching the rotary
remoteEN
You can detach the rotary remote as a safety DSP/Additional measure against theft.
Turn the remote clockwise while pressing down RELEASE.
information
1
2
Attaching the rotary remote
Align the four holes on the bottom of the rotary remote to the four catches on the holder and slide the rotary remote until it locks into place as illustrated.
2
1
Additional information 59