Receiving traffic announcements— TA/TP

By activating the Traffic Announcement (TA) and Traffic Programme (TP), you can automatically receive FM station broadcast traffic announcements as they occur. These settings function regardless of the current FM programme/source, CD/MD; the unit switches back to the original source when the bulletin is over.

Press (TA) repeatedly until “TA-ON” appears.

The unit starts searching for traffic information stations.

“TP” indicates reception of such stations, and “TA” flashes during an actual traffic announcement. The unit will continue searching for stations available with TP if “NO TP” is indicated.

To cancel all traffic announcements, select “TA- OFF.”

To

Press

Cancel current

(TA)

announcement

 

 

 

Tip

You can also cancel a current announcement by pressing (SOURCE) or (MODE).

Presetting the volume level of traffic announcements

You can preset the volume level of the traffic announcements so you won’t miss hearing them.

1 Turn the volume control dial to adjust the desired volume level.2 Press (TA) for 2 seconds.

“TA” appears and the setting is stored.

Receiving emergency announcements

If either AF or TA is on, the unit will switch to emergency announcements, if one comes in while listening to an FM station or CD/MD.

Presetting RDS stations with AF and TA setting

When you preset RDS stations, the unit stores each station’s AF/TA setting (ON/OFF) as well as its frequency. You can select a different setting (for AF, TA, or both) for individual preset stations, or the same setting for all preset stations. If you preset stations with “AF-ON,” the unit automatically stores stations with the strongest radio signal.

Presetting the same setting for all preset stations1 Select an FM band (page 13).2 Press (AF) and/or (TA) to select “AF-ON” and/or “TA-ON.”

Note that selecting “AF-OFF” and “TA-OFF” applies to non-RDS stations as well as RDS stations.

3 Press (MENU), then press either side of (DISC/PRESET) repeatedly until “BTM” appears.

4 Press (ENTER) until “BTM” flashes.Presetting different settings for each preset station1 Select an FM band, and tune in the desired station (page 14).

2 Press (AF) and/or (TA) to select “AF-

ON” and/or “TA-ON.”

3 Press the desired number button ((1) to (6)) on the card remote commander until “MEM” appears.

Repeat from step 1 to preset other stations.

16