Sony CDX-GT930UI Adjusting the angle of the front panel, (ANGLE), 1Press and hold (ANGLE), Attaching the front panel, 3Press any button on the unit except

3Slide the front panel to the left, then gently pull out the front panel towards you.

(OFF)

Notes

•Do not drop or put excessive pressure on the front panel and display window.

•Do not subject the front panel to heat/high temperature or moisture. Avoid leaving it in a parked car or on a dashboard/rear tray.

Attaching the front panel

Place the hole A of the front panel onto the spindle B on the unit, then lightly push the left side in.

Press (SOURCE) on the unit (or insert a disc) to operate the unit.

A

B

Note

Do not put anything on the inner surface of the front panel.

Adjusting the angle of the front panel

(ANGLE)

1Press and hold (ANGLE).“Angle Adjust” will appear in the display.2Press (ANGLE) repeatedly until the front panel is angled accordingly.The front panel can be set to 3 positions.3Press any button on the unit except(ANGLE).The display returns to normal reception mode.

If no button is pressed for 30 seconds, the display returns to normal reception mode.

Tips

•After the front panel slides down (to insert the disc), it returns to the position you set again automatically.

•The front panel angle you set is stored in the unit. When turning the ignition off, the angle returns to its default position, then turning the ignition on, the front panel is angled you set.

7