Getting StartedResetting the unit

Before operating the unit for the first time, or after replacing the car battery or changing the connections, you must reset the unit.

Detach the front panel and press the RESET button with a pointed object, such as a ballpoint pen.

RESET button

Note

Pressing the RESET button will erase the clock setting and some stored contents.

Setting the clock

The clock uses a 24-hour digital indication.

1Press and hold (SEL).

The setup display appears.

2Press (SEL) repeatedly until “CLOCK-

ADJ” appears.

3Press (DSPL).

The hour indication flashes.

4Press the volume +/– button to set the hour and minute.

To move the digital indication, press (DSPL).

5Press (SEL).

The clock starts and the next setup display appears.

6Press and hold (SEL).

The setup is complete.

To display the clock, press (DSPL). Press (DSPL) again to return to the previous display.

Tip

You can set the clock automatically with the RDS feature (page 10).

With the card remote commander

In step 4, to set the hour and minute, press M or m.

Detaching the front panel

You can detach the front panel of this unit to prevent theft.

Caution alarm

If you turn the ignition switch to the OFF position without detaching the front panel, the caution alarm will sound for a few seconds. The alarm will only sound if the built-in amplifier is used.

1Press (OFF).

The unit is turned off.

2Press , then pull it off towards you.

(OFF)

Notes

•Do not drop or put excessive pressure on the front panel and display window.

•Do not subject the front panel to heat/high temperature or moisture. Avoid leaving it in a parked car or on a dashboard/rear tray.

Tip

When carrying the front panel, use the supplied front panel case.

Attaching the front panel

Engage part A of the front panel with part B of the unit, as illustrated, and push the left side into position until it clicks.

DEMO mode

When the unit is turned off, the clock is displayed first, then demonstration (DEMO) mode starts the demonstration display.

To cancel the DEMO mode, set “DEMO-OFF” in setup (page 11) while the unit is turned off.

A

B

 

Note

4

Do not put anything on the inner surface of the front

panel.