2 Press the volume control up or down repeatedly to adjust the selected item. After 3 seconds, the setting is complete and the display returns to normal play/reception mode.
With the card remote commander
In step 2, to adjust the selected item, press <, M, , or m.
Customizing the equalizer curve
— EQ3
“Custom” of EQ3 allows you to make your own equalizer settings.
1 Select a source, then press (EQ3) repeatedly to select “Custom.”
2 Press (SEL) repeatedly until “LOW
Center Frequency” appears.
3 Press the volume control up or down repeatedly to select the desired frequency.
LOW Frequency can be set to 60 Hz or 100 Hz.
4 Press (SEL).
5 Press the volume control up or down repeatedly to adjust the volume level. The volume level is adjustable in 1 dB steps, from –10 dB to +10 dB.
Other functionsChanging the sound settingsAdjusting the sound characteristics

You can adjust the balance, fader, and subwoofer volume.

1Press (SEL) repeatedly until “Balance,” “Fader” or “Sub Woofer” appears.

The item changes as follows:

equalizer setting*1 t Balance (left-right) t Fader (rear-front) t

Sub Woofer (subwoofer volume)*2 t

AUX Level*3

*1 When EQ3 is activated (page 11).

*2 “– ∞” is displayed at the lowest setting, and can be adjusted up to 20 steps.

*3 When AUX source is activated (page 13).

6Press (SEL).

Repeat steps 3 to 6 to adjust “MID” and “HIGH.”

MID and HIGH frequencies differ but are set in the same way (MID: 500 Hz or 1.0 kHz; HIGH: 10.0 kHz or 12.5 kHz).

To restore the factory-set equalizer curve, press and hold (SEL) before the setting is complete.

After 3 seconds, the setting is complete and the display returns to normal play/reception mode.

Tip

Other equalizer types are also adjustable.

With the card remote commander

In step 3 and 5, to adjust the selected item, press <, M, , or m.

Adjusting setup items — SET

1Press and hold (SEL).

The setup display appears.

2Press (SEL) repeatedly until the desired item appears.

3Press the volume control up or down to select the setting (example “on” or “off”).

4Press and hold (SEL).

The setup is complete and the display returns to normal play/reception mode.

Note

Displayed items will differ, depending on the source and setting.

With the card remote commander

In step 3, to select the setting, press < or ,.

The following items can be set (follow the page reference for details):

“z” indicates the default settings.

Clock Adjust (page 4)

CT (Clock Time)

To set “on” or “off” (z) (page 9, 10).

Beep

To set “on” (z) or “off.”

continue to next page t

11