Sony CHC-TB10 12GB, Presetting radio stations (continued), number, station, stations, disappear, manual tuning, 6 Press ENTER, Other operations, select “FM” or “AM”

Presetting radio stations (continued)	Other operations
Setting presets through	To	Do this
	Tune in a	Follow the procedure described in
manual tuning
	station with a	“Setting presets through manual
1 Press TUNER/BAND repeatedly to	weak signal	tuning”.
	Stop setting	Press TUNER MEMORY on the
select “FM” or “AM”.	presets	remote.
2 Press PLAY MODE/TUNING MODE
	Stop scanning	Press x.
repeatedly until “AUTO” and “PRESET”
	Change the	Start over from step 1.
disappear.
	preset station
When you use the remote in step 3, skip this
	Change the	Start over from step 1.
procedure.
	preset number
3 Slide the knob to – or to + (or press
TUNING – or + on the remote)	To change the AM tuning interval
repeatedly to tune in the desired	(except for the European model)
station.	The AM tuning interval is factory-set to 9 kHz
4 Press TUNER MEMORY/DIRECTION (or
	(10 kHz in some areas). To change the AM
press TUNER MEMORY on the remote).	tuning interval, tune in any AM station first,
5 Slide the knob to – or to + (or press	then turn off the system. While holding
	ENTER, turn the system back on. When you
PRESET – or + on the remote)
	change the interval, all the AM preset stations
repeatedly to select the desired preset
	are erased. To reset the interval, repeat the
number.
	same procedure.
	Note
	You cannot change the AM tuning interval in the
	Power Saving Mode.
	Tips
Preset number	• The preset stations are retained for about a day even
6 Press ENTER.	if you disconnect the power cord or if a power
	failure occurs.
The station is stored.	• To improve broadcast reception, reorient or move
7 Repeat steps 1 to 6 to store other	the supplied antennas near a window or outdoors.

stations.

12GB