![](/images/backgrounds/16774/16774-2011x1.png)
Other Operations
To | Do this |
Tune in a station with a | Follow the procedure |
weak signal | described in “Setting |
| presets through manual |
| tuning”. |
|
|
Change the preset | Start over from step 1. |
number |
|
|
|
Set another station to | Start over from step 1. |
an exsisting preset | After step 3, press |
number | PRESET + or – |
| repeatedly to select the |
| preset number where you |
| want to store the other |
| station and then press |
| ENTER/PGM (TUNER |
| MEM/ENTER/PGM on |
| the remote). |
|
|
To change the AM tuning interval (except for the European and Middle Eastern models)
Disconnect the power cord from the wall outlet first, and then set the AM FREQ STEP switch at the rear to 9 kHz or 10 kHz.
Tip
The preset stations are retained for half a day even if you unplug the power cord or if a power failure occurs.
Listening to the radio
You can listen to a radio station either by selecting a preset station, or by manually tuning in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first (see “Presetting radio stations” on page 10).
1 Press TUNER (TUNER/BAND on the remote).
2 Press PRESET + or – repeatedly to tune in the desired preset station.
The preset number appears in the display for a few seconds.
When only one station is preset, only that station is tuned.
Listening to non-preset radio station
— Manual Tuning
1 Press TUNER (TUNER/BAND on the remote) repeatedly to select “FM” or “AM”.
2 Turn TUNING +/– (or press TUNING + or
–on the remote) repeatedly to tune in the desired station.
Tip
To improve broadcast reception, adjust the antenna (for FM) or reorient the main unit itself (for AM).