Adjusting the convergence (CONV)
The CONV settings allow you to adjust the quality of the picture by controlling the convergence. The convergence refers to the alignment of the red, green, and blue color signals.
If you see red or blue shadows around letters or lines, adjust the convergence.These settings are stored in memory for all input signals.
1Press the center of the control button.
The main MENU appears on the screen.
2Move the control button to highlight 
CONV and press the center of the control button again.
3First move the control button m/M to select 
for
horizontal adjustment, or 
for vertical adjustment. Then move the control button </, to adjust the convergence.
Additional settings (OPTION)
You can manually degauss (demagnetize) the monitor, adjust the moire cancellation level, change the menu position, and lock the controls.
1Press the center of the control button.
The main MENU appears on the screen.
2Move the control button to highlight 
OPTION and press the center of the control button again.
The monitor is automatically demagnetized (degaussed) when the power is turned on.
To manually degauss the monitor, first move the control button m/Mto select 
(DEGAUSS). Then move the control button ,.
The screen is degaussed for about 5 seconds. If a second degauss cycle is needed, allow a minimum interval of 20 minutes for the best result.
Adjusting the moire*If elliptical or wavy patterns appear on the screen, adjust the moire cancellation level.
To adjust the amount of moire cancellation, first movethe control button m/M to select 
(MOIRE ADJUST). Then move the control button </, until the moire effect is at a minimum.
*Moire is a type of natural interference which produces soft, wavy lines on your screen. It may appear due to interference between the pattern of the picture on the screen and the phosphor pitch pattern of the monitor.
Example of moire
(OSD H POSITION)for horizontal adjustment, or 
(OSD V POSITION) for vertical adjustment. Then move the control button </, to shift the
12