Sony CPD-E500 Setup, Step 1: Connect your monitor to your computer, Step 2: Connect the power cord, xConnecting to an IBM PC/AT or compatible computer

Setup

Before using your monitor, check that the following accessories are included in your carton:

•Power cord (1)•Macintosh adapter (for beige system) (1)•Setup Disk (1)•Warranty card (1)•Notes on cleaning the screen’s surface (1)•This instruction manual (1)

Step 1: Connect your monitor to your computer

Turn off the monitor and computer before connecting.

Note

Do not touch the pins of the video signal cable connector as this might bend the pins.

xConnecting to an IBM PC/AT or compatible computer

AC IN

to video output

IBM PC/AT or compatible computer

xConnecting to a Macintosh or compatible computer

AC IN

Macintosh adapter (for beige system) (supplied)*

Macintosh or	to video
compatible computer	output

*Connect the supplied Macintosh adapter to the computer before connecting the cable.

This adapter is compatible with Macintosh LC, Performa, Quadra, Power Macintosh, and Power Macintosh G3 series computers that have two rows of pins. If you are connecting to the other version of Power Macintosh G3 series with three rows of pins or models other than those stated above, you will need a different adapter (not supplied).

Step 2: Connect the power cord

With the monitor and computer switched off, first connect the power cord to the monitor, then connect it to a power outlet.

AC IN

to AC IN

to a power outlet

power cord (supplied)

6