Step 3: Turn on the monitor and computer

First turn on the monitor, then turn on the computer.The installation of your monitor is complete.If necessary, use the monitor’s controls to adjust the picture.If no picture appears on your screen•Check that the monitor is correctly connected to the computer.

•If NO INPUT SIGNAL appears on the screen, confirm that your computer’s graphic board is completely seated in the correct bus slot.

•If you are replacing an old monitor with this model and OUT OF SCAN RANGE appears on the screen, reconnect the old monitor. Then adjust the computer’s graphic board so that the horizontal frequency is between 30 – 109 kHz, and the vertical frequency is between 48 – 160 Hz.

For more information about the on-screen messages, see “Trouble symptoms and remedies” on page 16.

For customers using Windows 95/98

To maximize the potential of your monitor, install the new model information file from the supplied Setup Disk onto your PC.

This monitor complies with the “VESA DDC” Plug & Play standard. If your PC/graphics board complies with DDC, select “Plug & Play Monitor (VESA DDC)” or this monitor’s model name as the monitor type in the “Control Panel” of Windows 95/98. If your PC/graphics board has difficulty communicating with this monitor, load the Setup Disk and select this monitor’s model name as the monitor type.

For customers using Windows NT4.0

Monitor setup in Windows NT4.0 is different from Windows 95/98 and does not involve the selection of monitor type. Refer to the Windows NT4.0 instruction manual for further details on adjusting the resolution, refresh rate, and number of colors.

Selecting the on-screen menu language (LANG)

English, French, German, Spanish, Italian, Dutch, Swedish, Russian and Japanese versions of the on-screen menus are available. The default setting is English.

1Press the center of the control button.See page 9 for more information on using the control button.

MENU

MENU

 

 

KO UNEM

 

NERCS

RETNC

 

VNOC

 

MOEG

 

TIE

ROLC

 

GNAL

 

EZIS

NOITP

2Move the control button to highlight LANG and press the center of the control button again.

MENU

L ANGUAGE

 

 

ENGL I SH

 

 

FRAN A I S

 

 

DEUT SCH

 

 

ESPA OL

US

 

I T A L I ANO

 

NEDER L ANDS

 

 

SVENSKA

 

3Move the control button m/M to select a language.•ENGLISH•FRANÇ AIS: French•DEUTSCH: German•ESPAÑ OL: Spanish•ITALIANO: Italian•NEDERLANDS: Dutch•SVENSKA: Swedish• : Russian•: Japanese

To close the menu

Press the center of the control button once to return to the main MENU, and twice to return to normal viewing. If no buttons are pressed, the menu closes automatically after about 30 seconds.

To reset to English

Press the RESET button while the LANGUAGE menu is displayed on the screen.

7