Frame ground

When installed the CD writer unit should have its metal chasis in contact with a grounded metal area of the computers frame.

This normally occurs naturally when the drive is mounted into one of the computers spare drive bays.

AUDIO OUT connector

The pin assignment for the audio out connector is as follows:

pin

Audio Signal

 

 

1

R signal

2

ground

3

ground

4

L signal

 

 

SCSI INTERFACE connector

1Firmly insert one end of the interface cable into the INTER- FACE CONNECTOR. Pin 1 is generally identified by a red stripe on the ribbon cable.

Pin 1

INTERFACE

CONNECTOR

INTERFACE cable

2Attach the other end of the cable to the SCSI Controller. If you have other SCSI devices connected to your SCSI controller then refer to the SCSI rules set out on page 11 for termination requirements.

NOTE: Always use the shortest possible SCSI cables. Long SCSI cables can introduce system problems.

Closing the Computer

Refer to your computers user manual for instructions on how to close the computer.

14

Installing the Drive Unit into the Computer

Installing the Drive Unit into the Computer

15