Settings for the Speakers
(SPEAKER SETUP)
To obtain the best possible surround sound, set the size of the speakers you have connected and their distance from your listening position. Then use the test tone to adjust the volume and the balance of the speakers to the same level.
Select “SPEAKER SETUP” in the setup display. For details, see “Using the Setup Display” (page 67).
The default settings are underlined.
SPEAKER SETUP
SIZE:
DISTANCE:
LEVEL:
BALANCE:
TEST TONE:
To return to the default setting
Select the item, then press CLEAR.
xSIZE
When you do not connect center or rear speakers, or move the rear speakers, set the parameters for CENTER and REAR. Since the front speaker and subwoofer settings are fixed, you cannot change them. The default settings are underlined.
•FRONT
—YES
•CENTER
—YES: Normally select this.
—NONE: Select this if no center speaker is used.
•REAR
—BEHIND (LOW), BEHIND (HIGH), SIDE (LOW), SIDE (HIGH): Specify the position and height to implement the Digital Cinema Surround modes.
—NONE: Select this if no rear speaker is used.
•SUBWOOFER
—YES
Notes
•When you select an item, the sound cuts off for a moment.
•Depending on the settings of other speakers, the subwoofer may output excessive sound.
Specifying the rear speaker position
and height
If you select anything other than “NONE” in “REAR,” specify the position and height of the rear speakers. The default setting is underlined.
BEHIND (LOW) | Select this if the rear |
| speakers are located in |
| section B and D. |
|
|
BEHIND (HIGH) | Select this if the rear |
| speakers are located in |
| section B and C. |
|
|
SIDE (LOW) | Select this if the rear |
| speakers are located in |
| section A and D. |
|
|
SIDE (HIGH) | Select this if the rear |
| speakers are located in |
| section A and C. |
|
|
These parameters are not available when “REAR” is set to “NONE.”