Step 3: TV and Video Component Hookups
Required cords
Video cord for connecting a TVYellow
Audio/video cords (not supplied)When connecting a cord, be sure to match the
Yellow (Video)
White (L/audio)
Red (R/audio)
Terminals for connecting video componentsConnect the | To the |
TV | MONITOR OUT jack |
|
|
VCR | VIDEO 1 jacks |
|
|
Digital satellite receiver | VIDEO 2 jacks |
|
|
Notes
•When you select VIDEO 1 using the FUNCTION button, the signal is not output via VIDEO OUT and AUDIO OUT L/R jacks (VIDEO 1).
•When you use the VIDEO 1 line outputs, please set the system to 2CH STEREO mode. If the system is not in 2CH STEREO mode, the line outputs may not function properly.
•When the mode of the system is set to “DVD,” the signal is output from the S VIDEO OUT or COMPONENT OUT jacks.
•When the mode of the system is set to “DVD” and “PROGRESSIVE” is selected in “SCREEN SETUP,” the signal is output only from the COMPONENT OUT jacks.
Tips
•When using the S video jack instead of the video jacks, your TV monitor must also be connected via an S video jack. S video signals are on a separate bus from the video signals and will not be output through the video jacks.
•When using the COMPONENT VIDEO OUT jacks (Y, PB/CB, PR/CR) instead of the video jacks, your TV monitor must also be connected via COMPONENT VIDEO OUT jacks (Y,PB/CB, PR/CR). If your TV accepts progressive format signals, you must use this connection and set “COMPONENT OUT” to “PROGRESSIVE” in “SCREEN SETUP” (page 64).