Pictures from connected devices are not displayed on the LCD screen or the viewfinder.
•Set [DISP OUTPUT] to [LCD PANEL] (p. 54).
•You cannot input a signal to your camcorder if you press DISP/BATT INFO while [DISP OUTPUT] is set to
Pictures from connected devices cannot be zoomed.
• You cannot zoom the pictures from connected devices on your camcorder (p. 23).
Time code and other information appears in the display of the connected device.
•Set [DISP OUTPUT] to [LCD PANEL] while connected with an A/V connecting cable (p. 54).
You cannot dub correctly using the A/V connecting cable.
•Set [DISP OUTPUT] to [LCD PANEL] (p. 54).
•The A/V connecting cable is not connected properly. Make sure that the A/V connecting cable is connected to the proper jack, i.e. to the output jack of a device you are dubbing a picture from (for
New sound added to a recorded tape is not heard.
•Adjust [AUDIO MIX] from the [ST1] (original sound) side until the sound is heard appropriately (p. 63).
Still pictures cannot be dubbed from a tape to a “Memory Stick Duo.”
•You cannot record or a distorted picture may be recorded if the tape has been used repeatedly for recording.
Movies cannot be dubbed from a tape to a “Memory Stick Duo.”
•You cannot record or a distorted picture may be recorded in the following situations:
–The tape has a blank section.
–The tape has been used repeatedly for recording.
–The input signal has been interrupted or cut.
You cannot input pictures.
•You cannot input pictures while [DISP OUTPUT] is set to
•You cannot input pictures if you press the DISP/BATT INFO button.
The picture appears distorted or dark.
Troubleshooting
• A/V connecting cables are connected to both your camcorder and the Handycam Station. Disconnect one of the A/V connecting cables.
Continued 91