Warning indicators and messages
Self-diagnosis display/Warning indicators
If indicators appear on the screen, check the following. See the page in parentheses for details.
Indication | Cause and/or Corrective Actions |
|
|
C:ss : ss/E:ss : ss (Self- | Some symptoms can be fixed by yourself. If the problem persists even after |
diagnosis display) | you tried a couple of times, contact your Sony dealer or local authorized |
| Sony service facility. |
| C:04:ss |
| cA battery pack that is not an “InfoLITHIUM” battery pack is being used. |
| Use an “InfoLITHIUM” battery pack. (p. 82) |
| C:21:ss |
| cMoisture condensation has occurred. Remove the cassette and leave your |
| camcorder for at least 1 hour, then |
| C:22:ss |
| cClean the head using a cleaning cassette (optional). (p. 85) |
| C:31ss / C:32ss |
| cSymptoms that are not described above have occurred. Remove and |
| insert the cassette, then operate your camcorder again. Do not perform |
| this procedure if moisture starts to condense. (p. 85) |
| cRemove the power source. Reconnect it again and operate your |
| camcorder again. |
| cChange the tape. |
| cPress the RESET button and operate your camcorder again. |
| E:61:ss / E:62:ss |
| cContact your Sony dealer or local authorized Sony service facility. |
| Inform them of the |
|
|
E (Battery level warning) | • The battery pack is nearly used up. |
| • Depending on the operating, environmental, or battery conditions, the |
| E indicator may flash, even if there are approximately 5 to 10 minutes |
| remaining. |
|
|
% (Moisture condensation warning)* | cEject the cassette, set the POWER switch to (CHG) OFF, and leave it for |
| about 1 hour with the cassette lid open. (p. 85) |
|
|
Q (Warning indicator pertaining to | Slow flashing: |
the tape) | • There is less than 5 minutes remaining on the tape. |
| • No cassette is inserted.* |
| • The |
| Fast flashing: |
| • The tape has run out.* |
|
|
78Troubleshooting