Sony DDM-2801CU, DDM-2802CNU, DDM-2802CU, DDM-2811CU Location and Function of Controls, Rear panel, Note, AC IN socket, I/F connector, 0AC IN socket, POWER indicator, ROTATION control, FAILURE indicator

Location and Function of Controls

Rear panel

R/G/B VIDEO IN connectorsLANDING SENSOR connectorI/F connectorMAIN circuit breaker1R/G/B VIDEO IN connectors (BNC type)

These connectors are used for inputting the R (red), G (green) and B (blue) signals. The connectors are terminated at 50 ohms.

HD input connectorVD input connectorPOWER indicatorFAILURE indicatorROTATION controlAC IN socket7POWER indicator (green)This indicator lights when the POWER switch on the front panel is turned on.

2LANDING SENSOR connector (8 pin)

This connector is used when adjusting uneven color by connecting the optional landing sensor DDM-LS10.

3I/F connector (D-sub 15 pin)

This I/F (interface) connector is used when externally adjusting distortion, convergence, color temperature, etc. by connecting the optional Remote controller DDM- RM10.

4MAIN circuit breakerSet this circuit breaker to the I (on) position when using this unit.

8FAILURE indicator (red)

This indicator lights when the circuits inside the unit are not functioning correctly. Should this lamp light up, turn off the MAIN circuit breaker and consult Sony representative.

9ROTATION CONTROL

This control adjusts the picture rotation. Use a screwdriver etc. to turn the control.

Rotate the picture	Rotate the picture
clockwise	counterclockwise

5HD input connector (BNC type)

This connector is used for inputting horizontal drive pulses (HD). The connector is terminated at 75 ohms.

6VD input connector (BNC type)

This connector is used for inputting vertical drive pulses (VD). The connector is terminated at 75 ohms.

0AC IN socketConnect an AC power cord here.Note

When connecting to 1, 5 and 6, use a double-shielded coaxial cable.

14