Sony DRU-710A Appropriate Jumper Settings, Replacing your current optical drive with the DVD/CD rewritable drive, Use the same setting as the current drive’s jumper setting

Appropriate Jumper Settings

Depending on the settings of your computer, use one of the following configurations.

Hint

Your computer has two IDE connectors: a primary and a secondary connector. You can connect up to two devices to each connector using cables (one master device and one slave device per cable; hard disk, CD, or DVD drives, etc.). The hard disk of your computer is normally connected on the primary IDE cable as the master device. Before connecting the drive, refer to the items below to determine your situation, and then place the jumper in the MASTER or SLAVE position.

Replacing your current optical drive with the DVD/CD rewritable drive

Connect the drive as follows.

DVD/CD rewritable drive

1st drive

Hard disk drive (usually)

MASTER

Use the same setting as the current drive’s jumper setting.

Setup

Current optical drive

Primary	Secondary
IDE connector	IDE connector

15