ADisk tray

Insert discs here, label side up.

Hint

When you insert a disc into the drive, make sure that it is under the four pins. When using the drive vertically, make sure that you set the disc inside the two lower pins.

BEject button

Press to open and close the disc tray.

CBusy indicator

Indicates the drive status.

Lit : The drive is reading data, playing back an audio CD, or writing packets.

Blinking: The drive is writing data (disc-at-once, track-at-once), formatting a disc, or deleting1) data from a disc.

Off : The drive is in a state other than those outlined above.

1)Some drives indicate this state with the lit indicator.

DEmergency eject hole

If you cannot open the disc tray with the eject button, turn off your computer, and then insert a thin, elongated object into this hole to eject the disc tray manually.

About 40 mm (1.6 in)

EDo not use.FDo not use.GAnalog audio connector

Analog stereo audio output. Using an audio cable, connect to the audio connector of a computer with a sound card.

HJumper

A jumper is set on the appropriate pins before connecting the drive.

 

 

 

 

 

 

 

CS EL

 

 

 

 

 

 

 

CS EL

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SLAVE

 

 

 

 

 

 

 

SLAVE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

MASTER

 

 

 

 

 

 

 

MASTER

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Jumper

 

pins

Jumper

 

 

pins

 

 

IIDE connector

Connect to the computer with the supplied IDE flat cable.

JPin 1

The location of this pin determines the proper orientation of the connection cable.

KPower connector

Connect the connector of the computer’s internal power supply.

DC INPUT

5V GND 12V

Introduction

9