Menu 220 Using Setup Add (forDSR-370/570WS only)

Use this menu to add setup to the playback video signals.

1 Display menu 220.

The setup add is factory-set to oFF.

Blinking

Setup add on/oFF indication

Menu 221 Using Setup Remove(for DSR-370/570WS only)

Use this menu to remove setup from a video signal which contains setup (when the DSBK-501/501P is fitted).

1 Display menu 221.

Setup remove is factory-set to on.

Blinking

Setup remove on/oFF indication

If the setting does not need to be changed, press the MENU button to close the menu.

2 Press the SHIFT button to make the setup add on/ oFF indication start blinking, then press the ADVANCE button to change the setting to on.

3 Press the RESET/(MENU SET) button and then the MENU button.

The settings are recorded and display window returns to the display shown before the VCR menu.

Note

During recording the signal of the image being shot contains setup add, when it is output from the camcorder’s S VIDEO OUT and MONITOR OUT connectors.

During playback, the setup is removed from the output video signal.

To have the setup added during playback, set the setup add to on.

If the setting does not need to be changed, press the MENU button to close the menu.

2 Press the SHIFT button to make the setup remove on/oFF indication start blinking, then press the ADVANCE button to change the setting to on.

3 Press the RESET/(MENU SET) button and then the MENU button.

The settings are recorded and display window returns to the display shown before the VCR menu.

Note

Even if you set setup remove to on, the video signals output from the camcorder’s MONITOR OUT connector during recording will contain setup. However, signals with setup removed are recorded onto tape.

Settings and Adjustments 5 Chapter

Chapter 5 Adjustments and Settings

125