Set the W. BAL switch to A or B.

White Balance Adjustment

Settings and Adjustments 5 Chapter

Adjusting the white balance ensures that as lighting conditions change white objects remain white in the image and tones remain natural.

The color of light emitted varies from one light source to another, and as the lighting changes the apparent color of an illuminated subject changes. It is therefore, necessary to adjust the white balance each time the principal lighting source changes.

Saving an Appropriate WhiteBalance Value in Memory

You can save two white balance values in separate memories, A and B. Unless changed, the saved values are retained for approximately ten years, even when the camcorder is turned off.

Once a value is saved, you can automatically restore the adjustment by moving the W. BAL switch to the A or B position. This makes shooting under alternating lighting conditions easy.

Separate white balance values for each FILTER control setting

In the default case, as described above, the same two A and B white balance values apply to all four settings of the FILTER control. It is possible, however, to change the AWB MEM setting in advanced menu page 3 (see page 101) so that there are eight possibly different values for the A and B positions.

4

1

2 1

5 1 3

1 Make the following settings.

•POWER switch: ON

•OUTPUT/DL/DCC+ switch: one of the CAM positions

•Lens iris selector: A (automatic)

•ATW button: off

2 Set the FILTER control according to the lighting conditions. (See page 57.)

3

4 Arrange a white subject (paper, cloth, etc.) under the same lighting conditions as for shooting, and zoom in on it so that as far as possible the whole screen is white.

The minimum white area requirements for the adjustment are shown in the following figure.

Area of white within this rectangle should be

Center of the screen equivalent to at least 10% of the image area.

approximately

 

 

 

 

 

 

 

approximately

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

70% of the

 

 

 

 

 

 

 

70% of the

height of the

 

 

 

 

 

 

 

width of the

 

 

 

 

 

 

 

image

 

 

 

 

 

 

 

image

5 Push the WHT/BLK switch in the WHT direction and release.

The white balance adjustment is carried out. During the adjustment the legend “AUTO WHITE -OP-” appears in the viewfinder.

After a few seconds the adjustment is complete, and the legend in the viewfinder changes to “AUTO WHITE -OK-” plus a color temperature, as shown in the following figure.

The adjustment value is automatically saved in memory A or B as selected above.

126

Chapter 5 Adjustments and Settings