You have to designate the lens number according to the types of your lens.
If the number is not designated properly, strange color may appear on the upper and lower of the screen when shooting a white subject.
Set the number in advanced menu page 4 (page 89)
Lens | Product |
number |
|
|
|
1 | Fujinon: |
| A12X6.8 BRM |
| Canon: |
|
|
2 | Fujinon: A10X4.8 BEVM/BERD, A15X8 BERM/ |
| BERD, A16X9 BERM, A20X8 BEVM/BERD, |
| A19X8.7 BERM, A19X8.7 BRM |
| Canon: J9aX5.2B IRS/IAS, J15aX8B IRS/IAS |
|
|
3 | Canon: J21aX7.8B IRS/IAS, YJ18X9B IRS |
|
|
4 | Set up the data with Sony dealer. |
|
|
If you use the lens that is not mentioned above, set the lens number as follows:
•When using the lens without the extender, set it to 1.
•When using the lens with the extender, set it to 2.
•When using the lens with the ratio converter, set it to 2.
You can also set it more precisely at Sony dealer, according to your lens. In this case, set it to 4.
Adjusting the Iris SensitivityYou usually need not adjust the iris sensitivity because lenses are equipped with iris sensitivity adjustment function.
In auto iris mode, if hunting or response delay happens, adjust the iris sensitivity using the iris sensitivity trimmer.
Iris sensitivity trimmer (S or IRIS GAIN is indicated.)
IRIS
GAIN
You can see the iris sensitivity trimmer when removing the gum cap on the front of the lens driving unit. Use a
For more information, refer to the operating instructions for the lens (or consult the lens maker).
MacrophotographyUse the macro function when the subject is short from the front of the lens.
2 3
1
4
ZOOM
SERVO MANU.
1 Bring the lens up to the subject so that the image is the required size.
2 Move the focus ring to the closest focus position.
3 Press the M button and turn the MACRO ring fully in the direction shown by the arrow.
4 Move the ZOOM selector to the MANU. position, and turn the zoom ring to focus the image.
EndingReturn the MACRO ring to its original position (turn fully in the opposite direction to the arrow in the figure).
Reducing the size of the imageAfter completing steps 1 to 4 above, if you wish to reduce the size of the image, turn the MACRO ring back slightly, then use the zoom ring again to focus the image.
Settings and Adjustments 5 Chapter
Chapter 5 Adjustments and Settings | 121 |