Chapter 6 ClipLink Operation
94 Chapter 6 ClipLink Operation
You can rewrite the reel number, Mark IN/OUT points
and OK/NG status included in the ClipLink log data.
Changing the Reel Number
To change the reel number of the data item selected on
the ClipLink log data list, proceed as follows.
1Using the jog/shuttle dial, move the selection mark
(asterisk) to the desired data item on the ClipLink
log data list.
2Hold down the STOP button and press the SET
button.
The following setting screen appears.
3Turn the jog/shuttle dial to select the digit to
change.
Rotating the jog/shuttle dial clockwise moves the
current digit position to the right, and
counterclockwise moves it to the left.
4Hold down the search button and turn the jog/
shuttle dial to change the digit indicated by an
arrow (µ).
5Repeat steps 3 and 4 until the settings for all digits
are complete.
6When all digits have been set, hold down the
ENTRY/SHIFT button and press the TRIM+/
MARK button.
The reel number changes.
7Hold down the STOP button and press the SET
button.
This returns to the original ClipLink log data list.
Note
If you carry out step 7 skipping step 6, the original
ClipLink log data list appears again on the monitor
and, in this case, the reel number is not rewritten.
Changing Mark IN/OUT Points
To change Mark IN/OUT points selected on the
ClipLink log data list, perform the following
procedure.
When Mark IN/OUT points are rewritten to the
cassette memory, the frame digits of the address data
are processed as follows.
For Mark IN point: Any frame-digits value is
counted as 1 second.
For Mark OUT point: Any frame-digits value is
ignored.
Rewriting ClipLink Log Data2,6
4
1,3,4
SHUTTLE JOG
p
STOP
STANDBY
SET
(003/196)
*REEL NO (XXXXXXXX)
REEL NO (YYYYYYYY)
CLIPLINK LOG DATA LIST
1,3,5
46
2,7
3,5
2,4,6
7,8
8
TRIM
LIST MARK
CLIP
LINK
ENTRY SHIFT
IN OUT
–+
PLAY
4