NORMAL Select this when the player is connected to an audio component that does not conform to Dolby Surround (Pro Logic). All of the output signals are downmixed to 2 channels without the Dolby Surround (Pro Logic) effect.

xDIGITAL OUT

Selects if audio signals are output via the DIGITAL OUT (OPTICAL or COAXIAL) jack.

ON Normally, select this position. When you select “ON,” set “DOLBY DIGITAL,” “DTS”, and “48kHz/ 96kHz PCM”. For details on setting these items, see “Setting the digital output signal.”

OFF The player does not output the audio signals via the DIGITAL OUT (OPTICAL or COAXIAL) jack. The influence of the digital circuit upon the analog circuit is minimal.

Setting the digital output signal

Switches the method of outputting audio signals when you connect the following component using an optical or a coaxial digital cord via the DIGITAL OUT (OPTICAL or COAXIAL) jack.

—Amplifier (receiver) with digital input jack

—Amplifier (receiver) with a built-in DTS or DOLBY DIGITAL decoder

—MD or DAT deck

For connection details, see page 19.

Select “DOLBY DIGITAL,” and “DTS” after setting “DIGITAL OUT” to “ON.”

AUDIO SETUP

AUDIO ATT:

 

OFF

AUDIO DRC:

 

STANDARD

CENTER SPEAKER EQ:

FLAT

DOWNMIX:

DOLBY SURROUND

DIGITAL OUT:

 

ON

DOLBY DIGITAL:

 

D-PCM

DTS:

 

OFF

48kHz/96kHz PCM:

48kHz/16bit

xDOLBY DIGITAL

Selects the Dolby Digital signals output via the DIGITAL OUT (OPTICAL or COAXIAL) jack.

D-PCM

Select this when the player is

 

connected to an audio

 

component lacking a built-in

 

Dolby Digital decoder. You can

 

select whether the signals

 

conform to Dolby Surround (Pro

 

Logic) or not by making

 

adjustments to the

 

“DOWNMIX” item in “AUDIO

 

SETUP.” (page 70)

 

 

DOLBY

Select this when the player is

DIGITAL

connected to an audio

 

component with a built-in Dolby

 

Digital decoder.

 

If the player is connected to an

 

audio component lacking a built-

 

in Dolby Digital decoder, do not

 

set this. Otherwise, when you

 

play the Dolby Digital sound

 

track, a loud noise (or no sound)

 

will come out from the speakers,

 

affecting your ears or causing the

 

speakers to be damaged.

 

 

xDTS

Select if DTS signals are output via the DIGITAL OUT (OPTICAL and COAXIAL) jack.

OFF Select this when the player is connected to an audio component lacking a built-in DTS decoder. Note, however, that the DTS signals contained in a CD are output even if “OFF” is selected.

ON Select this when the player is connected to an audio component having a built-in DTS decoder.

If the player is connected to an audio component lacking a built-in DTS decoder, do not set this. Otherwise, when you play the DTS sound track, a loud noise (or no sound) will come out from the speakers, affecting your ears or causing the speakers to be damaged.

continued

Adjustments and Settings

71