VIRTUAL MULTI DIMENSION

Creates an array of virtual rear speaker positions higher than the listener from a single set of actual rear speakers.

This mode creates five sets of virtual speakers surrounding the listener at approximately a 30° angle of elevation. The effect differs according to “REAR” or “SIDE” setting of the rear speakers (page 85).

REAR

LR

LS

RS

SIDE

 

L

R

LS

RS

L:Front speaker (left)

R:Front speaker (right) LS: Rear speaker (left) RS: Rear speaker (right) : Virtual speaker

Notes

When you select one of the surround modes, turn off the surround setting of the connected TV or amplifier (receiver).

Not all discs will respond to the “TVS NIGHT” function in the same way.

To enjoy the multichannel audio through the 5.1CH OUTPUT jacks, correctly set each speaker position and distance (page 28, 85).

When the playing signal does not contain a signal for the rear speakers, you cannot hear the TVS effect.

When you select one of the TVS modes, the player does not output the sound of center speaker.

Make sure that your listening position is between and at an equal distance from your speakers, and that the speakers are located in similar surroundings.

If you use the DIGITAL OUT (OPTICAL or COAXIAL)/HDMI OUT jack and set “DOLBY DIGITAL” to “DOLBY DIGITAL,” and “DTS” to “DTS” in “AUDIO SETUP,” sound will come from your speakers but it will not have the SURROUND effect.

Adjustments Sound

57