Sony GDM-17SE2T manual Getting Started

Getting Started

This monitor will sync with any IBM or compatible system equipped with VGA or greater graphics capability. Although this monitor will sync to other platforms, including Macintosh and Power Macintosh system, a cable adapter is required. Please consult your dealer for advice on which adapter is suitable for your needs.

Step 1: With the computer switched off, attach the video signal cable to the monitor (HD15/5 BNC’s) and attach the other end to the video card.

to HD15

IBM or Compatible Computer

Step 2: With the monitor switched off, attach the power cord to the monitor and the other end to the power outlet.

Power cord (supplied)

to a wall outlet

Step 3: Turn on the monitor and computer.

Step 4: Switch the input connector according to the adjustment procedure on page 10.

Step 5: If necessary, adjust the user controls according to your personal preference.

The installation of your monitor is complete. Enjoy your monitor.

	to video output
Apple Computer	to video output
	Macintosh Adapter
	(supplied)

Video signal cable (supplied)

Notice

To comply with the limits of FCC Class B and IC Class B for digital device, please attach the supplied video signal cable for HD15 input or SMF-400 (sold separately) for BNC input. Furthermore, each cable has ferrite cores on it.

		to
IBM or Compatible Computer		VIDEO IN R/G/B
		SYNC IN HD/VD
	to video output	Video signal cable
Apple Computer	to video output	(not supplied)

Macintosh Adapter (supplied)

Note :

∙Use HD15 (Female)-HD15(Male without No.9 pin) adapter (not supplied) for current DOS computer which has no compliance of DDC 2AB and its No.9 pin is disconnected.

∙Supplied Macintosh adapter is compatible with Macintosh LC, Performa, Quadra and Power Macintosh series computers. Macintosh II series and some older version of PowerBook models may need an adapter with micro switches.

4