Performing initial setup
operations
Once you have hooked up the speakers and turned on the power, clear the receiver’s memory. Then specify the speaker parameters (size, position, etc.) and perform any other initial setup operations necessary for your system.
Tip
To check the audio output during settings (to set up while outputting the sound), check the connection (page 19).
Clearing the receiver’s memory
Before using your receiver for the first time, or when you want to clear the receiver’s memory, do the following.
1
2 Hold down ?/1 for 5 seconds.
“INITIAL” appears in the display. The following are reset to their factory settings.
•All settings in the SET UP, LEVEL and TONE menus.
•The sound field memorized for each function and preset station.
•All sound field parameters.
•All preset stations.
•All index names of input selectors and preset stations.
•The master volume is set to “VOL MIN”.
Performing initial setup operations
Before using your receiver for the first time, adjust SET UP parameters so that the receiver correspond to your system. For the adjustable parameters, see the table on page 47. See pages
Multi channel surround
setup
For the best possible surround sound, all speakers should be the same distance from the listening position (A).
However, the receiver lets you place the center speaker up to 5 feet closer (B) and the surround speakers up to 15 feet closer (C) to the listening position.
The front speakers can be placed from 3 to 23 feet from the listening position (A).
You can place the surround speakers either behind you or to the side, depending on the shape of your room (etc.). However, we recommend that you place the surround speakers behind you.
When placing surround speakers to your side
(long room)
| B | Sub woofer |
|
| |
A | A |
|
| 45° |
|
C |
| C |
| 90° |
|
| 20° |
|