Models of area code AU
(6 ohms 120 Hz – 20 kHz, THD 0.09%)
FRONT2): | 50 W/ch |
CENTER2): | 50 W |
SURR2): | 50 W/ch |
SURR BACK2): | 50 W |
(6 ohms 1 kHz, THD 0.7%) | |
FRONT2): | 60 W/ch |
CENTER2): | 60 W |
SURR2): | 60 W/ch |
SURR BACK2): | 60 W |
(6 ohms 1 kHz, THD 10%) |
|
FRONT2): | 100 W/ch |
CENTER2): | 100 W |
SURR2): | 100 W/ch |
SURR BACK2): | 100 W |
1) Measured under the following conditions: | |
|
|
Area code | Power requirements |
|
|
U, CA | 120 V AC, 60 Hz |
|
|
MX | 127 V AC, 60 Hz |
|
|
CEL, CEK, SP | 230 V AC, 50 Hz |
|
|
AU, E51 | 240 V AC, 50 Hz |
|
|
2)Depending on the sound field settings and the source, there may be no sound output.
Inputs (Analog)
Sensitivity: 800 mV | |
DVD, VIDEO 1, 2, 3 | Impedance: 50 k ohms |
|
|
Inputs (Digital) |
|
|
|
DVD (Coaxial) | Sensitivity: – |
| Impedance: 75 ohms |
|
|
VIDEO 2, | Sensitivity: – |
(Optical) | Impedance: – |
|
|
Outputs (Analog) |
|
|
|
MD/TAPE (OUT), | Voltage: 800 mV |
VIDEO 1 (AUDIO OUT) | Impedance: 10 k ohms |
|
|
SUB WOOFER | Voltage: 2 V |
| Impedance: 1 k ohm |
| |
Reproduction frequency range: | |
| 28 – 20,000 Hz |
Tone |
|
|
|
Gain levels | ±6 dB, 1 dB step |
|
|
Tuning range | 87.5 - 108.0 MHz | |
Antenna | FM wire antenna | |
Antenna terminals | 75 ohms, unbalanced | |
Intermediate frequency | 10.7 MHz | |
AM tuner section |
|
|
Tuning range |
|
|
Models of area code U, CA | - 1,710 kHz3) | |
With | ||
With | 531 | - 1,710 kHz3) |
Models of area code CEL, CEK, SP, AU | ||
With | 531 | – 1,602 kHz |
Models of area code E51 |
| - 1,610 kHz3) |
With | ||
With | 531 | - 1,602 kHz3) |
Models of area code MX |
|
|
With | - 1,610 kHz | |
Antenna | Loop antenna | |
Intermediate frequency | 450 kHz |
3) You can change the AM tuning scale to 9 kHz or | Additional | ||
| |||
10 kHz. After tuning in any AM station, turn off the |
| ||
receiver. While holding down PRESET TUNING + |
| ||
or TUNING +, press ?/1. All preset stations will be |
| ||
erased when you change the tuning scale. To reset | Information | ||
the scale to 10 kHz (or 9 kHz), repeat the procedure. | |||
| |||
Video section |
|
| |
Inputs/Outputs |
|
| |
Video: | 1 |
| |
General |
|
| |
Power requirements |
|
| |
|
|
| |
Area code | Power requirements |
| |
|
|
| |
U, CA | 120 V AC, 60 Hz |
| |
|
|
| |
MX | 127 V AC, 60 Hz |
| |
|
|
| |
CEL, CEK | 230 V AC, 50/60 Hz |
| |
|
|
| |
AU | 240 V AC, 50 Hz |
| |
|
|
| |
SP | 220 – 230 V AC, |
| |
| 50/60 Hz |
| |
|
|
| |
E51 | 120/220/240 V AC, |
| |
| 50/60 Hz |
| |
|
|
|
continued