6 Press control button V/v repeatedly to select “NAME IN”.

7 Press the control button or control button b to enter the parameter.

The cursor flashes and you can select a character. Follow the procedure given in “To create an index name” below.

To return to the previous display

Press control button B.

To create an index name

1Use control button V/v/B/b to create an index name.

Press control button V/v to select a character, then press control button B/b to move the cursor to the next position.

If you made a mistake

Press control button B/b until the character you want to change flashes, then press control button V/v to select the correct character.

Tip

You can select the character type as follows by pressing control button V/v.

Alphabet (upper case) t Numbers t Symbols

2Press the control button.

The entered name is registered.

Other Operations

Switching the audio input mode

(INPUT MODE)

You can select the audio input mode by setting the audio input mode when you connect components to both digital and analog audio input jacks on the receiver.

1 Turn INPUT SELECTOR on the receiver to select the input.

You can also use the input buttons on the remote.

2 Press INPUT MODE repeatedly on the receiver to select the audio input mode.

The selected audio input mode appears on the display.

Audio input modes

•AUTO IN

Gives priority to digital audio signals when there are both digital and analog connections. If there are no digital audio signals, analog audio signals are selected.

•COAX IN

Specifies the digital audio signals input to the DIGITAL COAXIAL jack.

•OPT IN

Specifies the digital audio signals input to the DIGITAL OPTICAL jack.

•ANALOG

Specifies the analog audio signals input to the AUDIO IN (L/R) jacks.

Note

Some audio input modes may not be set up depending on the input.

56US