Sony HT-DDW900 72

General

Power requirements

Area code	Power requirements
U, CA	120 V AC, 60 Hz

Power consumption

Area code	Power consumption

U	170 W

CA	230 VA

Power consumption (during standby mode)

0.2W

Dimensions (w/h/d) (Approx.)

	430 × 157.5 × 316 mm
	(16 7/8 × 6 2/8 × 12 4/8
	inches) including
	projecting parts and
	controls
Mass (Approx.)	8.0 kg (17 lb 11 oz)

Speaker section

•Front speakers (SS-MSP900)

•Center speaker (SS-CNP680)

•Surround speakers (SS-SRP900)

Front/center speakers Full range, magnetically

	shielded
Surround speakers	Full range
Speaker units	70 mm (2 3/4 inches) cone
	type
Enclosure type	Close type
Rated Impedance	6 ohms

Dimension (w/h/d) (Approx.) Front/center/surround speakers

155 × 96 × 101 mm

(6 1/8 × 3 6/8 × 4 inches)

Mass (Approx.) Front/center speakers

0.7 kg (1 lb 9 oz) Surround speakers 0.5 kg (1 lb 6 oz)

Sub woofer (SA-WP780)

AUDIO POWER

SPECIFICATIONS

POWER OUTPUT AND TOTAL HARMONIC DISTORTION: (Models of area code U only)

With 6 ohm loads, from 28 – 200 Hz; rated 120 watts, minimum RMS power, with no more than 0.7% total harmonic distortion from 250 milliwatts to rated output.

Speaker system	Active subwoofer,
	magnetically shielded
Speaker unit	200 mm (7 7/8 inches)
	cone type
Enclosure type	Acoustically loaded bass
	reflex
RMS output	150 W (6 ohms, 100 Hz,
	THD 10%)
Music power	200 W
Input	LINE IN (input pin jacks)
Power requirements

Area code	Power requirements

U, CA	120 V AC, 60 Hz

Power consumption

Area code	Power consumption

U, CA	80 W

Dimensions (w/h/d) (Approx.)
	270 × 331 × 380 mm
	(10 5/8 × 13 × 15 inches)
Mass (Approx.)	8.3 kg (18 lb 5 oz)

72US

Contents

Page Page About This Manual Note for the supplied remote Table of Contents Description and location of parts Page About the indicators on the display Page Rear panel Remote commander Page Page Page 1: Installing speakers 2: Connecting speakers To connect the speakers correctly 3a: Connecting the audio components Page Connecting components with analog audio jacks 3b: Connecting the video components Hooking up a TV monitor Hooking up a DVD player/DVD recorder 1Connecting audio 2Connecting video If you connect a DVD recorder Hooking up components with HDMI jacks Notes on HDMI connections Hooking up a satellite tuner Page 4: Connecting the antennas 5:Preparing the receiver and the remote 6:Selecting the speaker system 7:Calibrating the appropriate settings automatically Error and warning codes Error codes To rectify the error Error code and remedies Warning codes To change the settings manually Warning code and solution 8:Adjusting the speaker levels and balance Selecting a component To avoid damaging your speakers To listen to the sub woofer Listening/Watching a component Watching a DVD Navigating through menus Overview of the menus Page Adjusting the level Adjusting the tone Settings for the surround sound Settings for the tuner Settings for the audio Settings for the video Settings for the system Page Enjoying Dolby Digital and DTS Surround sound Types of A.F.D. mode Selecting a preprogrammed sound field Types of sound field available About DCS (Digital Cinema Sound) About CINEMA STUDIO EX modes To turn off the surround effect for movie/music Using only the front speakers and sub woofer (2CH STEREO) Resetting sound fields to the initial settings Listening to FM/AM radio If you cannot tune in a station Automatic tuning Using the controls on the receiver In case of poor FM stereo reception Direct tuning Presetting radio stations Naming preset stations Switching the audio input mode Watching component images from other inputs (COMPONENT VIDEO ASSIGN) Assignable inputs for component video input Watching HDMI images from other inputs Naming inputs Changing the display Using the Sleep Timer Recording using the receiver Programming the remote To cancel programming To activate the input after programming If programming is unsuccessful, check the following: To clear the memory of the remote The numeric codes corresponding to the component and the maker of the component To control a DAT deck To control an MD deck To control a tape deck To control an LD player To control a video CD player To control a DVD recorder To control a TV To control a satellite tuner or cable box To control a tuner To control a hard disc recorder Glossary Precautions Troubleshooting Page Page Remote control Error messages If you are unable to remedy the problem using the troubleshooting guide If the problem persist Reference sections for clearing the receiver’s memory Specifications Page Page Index