8 Press or b to enter the parameter.

The cursor flashes and you can select a character. Follow the procedure given in “To create an index name” below.

To create an index name

1Use V/v/B/b to create an index name. Press V/v to select a character, then press B/b to move the cursor to the next position.

If you made a mistake

Press B/b until the character you want to change flashes, then press V/v to select the correct character.

Tips

•You can select the character type as follows by pressing V/v.

Alphabet (upper case) t Numbers t Symbols

•To enter a blank space, you can

–press V/v repeatedly until a blank space appears in the display.

–press b without input a character.

2Press to enter the name. The entered name is registered.

Other Operations

Switching between digital and analog audio

(INPUT MODE)

You can select the audio input mode setting when you connect components to both digital and analog audio input jacks on the receiver.

1 Turn INPUT SELECTOR on the receiver to select the input.

You can also use the input buttons on the remote.

2 Press INPUT MODE repeatedly on the receiver to select the audio input mode.

The selected audio input mode appears on the display.

Audio input modes

xAUTO IN

Gives priority to digital audio signals when there are both digital and analog connections. If there are no digital audio signals, analog audio signals are selected.

xCOAX IN

Specifies the digital audio signals input to the DIGITAL COAXIAL jack.

xOPT IN

Specifies the digital audio signals input to the DIGITAL OPTICAL jack.

xANALOG

Specifies the analog audio signals input to the AUDIO IN (L/R) jacks.

Note

Some audio input modes may not be set up depending on the input.

59US

Operations Other