System Speaker the Up Setting and Up Hooking
Multi Channel Surround Setup
zAbout speaker distances
This amplifier allows you to input the speaker position in terms of distance. However, it is not possible to set the center speaker farther away than the front speakers. Also, the center speaker can not be set more that 1.5 meters (5 feet) closer than the front speakers.
Likewise, the rear speakers cannot be set farther away from the listening position than the front speakers. And they can be no more than 4.5 meters (15 feet) closer.
This is because incorrect speaker placement is not conducive to enjoy the surround sound.
Please note that, setting the speaker distance closer than the actual location of the speakers will cause a delay in the output of the sound from that speaker. In other words, the speaker will sound like it is farther away.
For example, setting the center speaker distance 1~2 m (3~6 feet) closer than the actual speaker position will create a fairly realistic sensation of being “inside” the screen. If you cannot obtain a satisfactory surround effect because the rear speakers are too close, setting the rear speaker distance closer (shorter) than the actual distance will create a larger soundstage. (1 foot corresponds to a 1 ms difference.)
Adjusting these parameters while listening to the sound often results in much better surround sound. Give it a try!
Note
If you are using a Sony DVD player together with this home theater system, set your DVD player to the following configuration:
Speakers | Settings |
|
|
Front | SMALL |
|
|
Center | SMALL |
|
|
Rear | SMALL |
|
|
Subwoofer | YES |
|
|
If you are using a non Sony DVD player, refer to the operating instructions supplied with the DVD player for speaker setup.
Adjusting the speaker volume
Use the remote while seated in your listening position to adjust the volume of each speaker.
Note
This amplifier incorporates a new test tone with a frequency centered at 800 Hz for easier speaker volume adjustment.
1Press ?/1 to turn on the amplifier.
2Press TEST TONE on the supplied remote.
You will hear the test tone from each speaker in sequence.
3Adjust the volume level so that the volume of the test tone from each speaker sounds the same when you are in your main listening position.
•To adjust the balance of the front right and front left speakers, press MENU </> to select the front balance parameter.
Use +/– on the remote to adjust the level. (or see page 27).
•To adjust the balance of the rear right and rear left speakers, press MENU </> to select the rear balance parameter.
Use +/– on the remote to adjust the level. (or see page 27).
•To adjust the volume level of the center speaker, press MENU </> to select the center parameter. Use +/– on the remote to adjust the level.
•To adjust the volume level of the rear speaker, press MENU </> to select the rear parameter.
Use +/– on the remote to adjust the level.
4Press TEST TONE on the remote again to turn off the test tone.
Note
The test tone cannot be output when the amplifier is set to 5.1CH/SAT.
zYou can adjust the volume level of all speakers at the same time
Rotate MASTER VOLUME on the amplifier or press MASTER VOL +/– on the remote.
18