Sony HTP-78DW After you have finished, Error codes, To rectify the error, Error codes and remedies, Warning codes, To change the settings manually

The measurement process will take a few minutes to complete.

When measurement ends, “COMPLETE” appears on the display and the settings are registered.

After you have finished

Disconnect the optimizer microphone from the receiver.

Note

Auto Calibration cannot detect the sub woofer. Therefore, the sub woofer settings will be maintained.

Tip

The Auto Calibration function will be canceled when you do the following during the measurement process:

–Press ?/1, input buttons or MUTING.

–Change the volume level.

–Press AUTO CAL again.

Error and warning codes

Error codes

When an error is detected during Auto Calibration, an error code will appear on the display cyclically after each measurement process as follows:

Error code t blank display t (error code t blank display)a) t PUSH t blank display

tENTER

a)Appears when there are more than one error code.

To rectify the error

1Record down the error code.2Press .You can also use ENTER on the receiver.3Press ?/1 to turn off the receiver.4Rectify the error.For details, see “Error codes and remedies” below.5Turn on the receiver and perform Auto Calibration again (page 26).

Error codes and remedies

Error	Explanation	Remedies
code
ERROR 10	The environment Make sure the
	is too noisy.	environment is
		quiet during Auto
		Calibration.
ERROR 11 The speakers are		Place your speakers
	placed too near	further away from
	the optimizer	the optimizer
	microphone.	microphone.
ERROR 20	The front	Check the front
	speakers are not	speakers
	detected or only	connection.
	one front speaker
	is detected.
ERROR 21	Only one	Check the surround
	surround speaker	speakers
	is detected.	connection.

Warning codes

During Auto Calibration, the warning code provides information on the measurement result. The warning code will appear on the display cyclically as follows:

Warning code t blank display t (warning code t blank display)b) t PUSH t blank display t ENTER

b)Appears when there are more than one warning code.

You can choose to ignore the warning code as the Auto Calibration function will automatically adjust the settings. You can also change the settings manually.

To change the settings manually

1Record down the warning code.

2Press .

You can also use ENTER on the receiver.

3Press ?/1 to turn off the receiver.

4Follow the solution provided in the “Warning codes and solutions” below.

5Turn on the receiver and perform Auto Calibration again (page 26).

continued

Started Getting

27GB