4 Press or b to enter the parameter.

You can also use ENTER or i on the receiver.

5 Press V/v repeatedly to select “T. TONE Y”.

You can also use U or u on the receiver. The test tone is output from each speaker in sequence as follows:

Front left t Center t Front right t Surround right t Surround left t Sub woofer

6 Adjust the speaker levels and balance using the LEVEL menu so that the level of the test tone sounds the same from each speaker.

For details, see “Adjusting the level (LEVEL menu)” (page 36).Tips

•To adjust the level of all speakers at the same time, press MASTER VOL +/–. You can also use MASTER VOLUME on the receiver.

•The adjusted value are shown on the display during adjustment.

To turn off the test tone

Repeat steps 1 to 5 above to select “T. TONE N”.You can also press any input buttons.

When a test tone is not output from the speakers

•The speaker cords may not be connected securely.•The speaker cords may have the short-circuit problem.

Started Getting

29GB