2-2 Connector Panel

1 TC OUTPUT connector

2 AC IN connector

 

 

3 REMOTE IN

 

 

connector

5 VIDEO OUTPUT

 

 

4 RS-232C connector

connectors

 

 

6 AUDIO MONITOR OUTPUT connectors

 

 

7 EXT SYNC

 

 

connectors

 

 

This illustration shows the J-H3 equipped with

 

 

an HKJ-101 i.LINK Interface Board.

 

 

Parts of Function and Location 2 Chapter

1TC OUTPUT (time code output) connector (BNC type ⋅1) (J-H3 only):

Outputs the playback time code.

2AC IN connector

Connects to an AC outlet using the power cord (not supplied).

Notes

•Place the unit near the AC outlet for easier reach of the breaker.

•Make sure to perform a ground connection for the unit before you plug the unit into the wall outlet. If you disconnect the grounding, unplug the unit from the wall outlet first.

3REMOTE IN (9P) (remote control signal input) connector (D-sub 9-pin, female) (J-H3 only):

Connects to a BVE series editor or other VTR using a 9-pin remote control cable (not supplied) to externally control the unit.

4RS-232C (RS-232C serial interface) connector (D-sub 9-pin, male)

Exchanges the RS-232C serial remote control signal and the VTR status signal with external devices such as a computer installed JZ-1.

5VIDEO OUTPUT connectors

SD (D CONV.) (SD output) connectors COMPOSITE (SUPER) (analog composite video

output) connector (Phono jack ⋅1): Outputs an analog composite video signal.

COMPOSITE (SUPER) (analog composite video output) connector (BNC type ⋅1): Outputs an analog composite video signal.

SDI (SUPER) (serial digital interface output) connector (BNC type ⋅1) (J-H3 only): Outputs video/audio signals in D1 format.

Chapter 2 Location and Function of Parts

2-7