Setting Up the Channel List
After you finish connecting tile TV, you can run tile Initial Setup to create a
list of available analog and digital channels. The Initial Setup screen appears
when you turn on the TV for the first time after hooking it up. Ifyou choose
to set up the channels at a later time, select the Auto Program option to scan
available channels (see page 66).
'f_ The Auto Program setup in the initial setup does not apply for
installations that usea cable box for all channel selection.
Using Initial Setup To run Initial Setup the first time you turn on your TV
tPress _(_° to turn on tile TV.
The Initial Setup screen appears.
2Press 4or ,!,to highlight the on-screen
display language. Then press @. The
message "First please connect cable and/or
antenna" appears. This may require 50+
minutes for completion and "Start auto
program now'?" appears.
3Press ,i, or ,!.to highlight Ye:
" s"then press @.
Auto Program performed through Initial Setup will automatically create a
list of receivable channels from both VHF/UHF antenna and cable TV
channels if both sources are connected.
,F,_Auto Program may take a while (20to 50 minutes) to complete. A
progress bar is displayed while available channels are being
scanned. Ifyou cancel the Auto Program before all receivable
channels are scanned, you may want to perform the task later (see
"To run Auto Program at a later time" below).
,2"_If you selected "No" during the Initial Setup, the Initial Setup
message will appear each time you turn on the TV as a reminder
until you complete the Auto Program.
To run Auto Program at a later time
1Select Settings in MENU, and then go to Channel settings.
2Select Auto Program then select Start.
_,_Auto Program will create a list of receivable channels for the
current input (VHF/UHF antenna or CABLE), You will be required to
run Auto Program for each RF inPut to create a list of available
channels from both inputs_
28