Sound Offset | Sets an independent volume level to each equipment connected to the TV. |
Manual Programme Preset
(Only in analogue mode)
Changes the available analogue channel setting.
Press F/f to select the programme number you want to modify. Then, press 
.
System
Presets programme channels manually.
1Press F/f to select “System”, then press 
.
2Press F/f to select one of the following TV broadcast systems, then press G.
B/G: For western European countries/regions
I: For the United Kingdom
D/K: For eastern European countries/regions
L: For France
~
•Depending on the country/region selected for “Country” (page 7), this option may not be available.
Channel
1Press F/f to select “Channel”, then press 
.
2Press F/f to select “S” (for cable channels) or “C” (for terrestrial channels), then press g.
3Tune the channels as follows:
If you do not know the channel number (frequency)
Press F/f to search for the next available channel. When a channel has been found, the search will stop. To continue searching, press F/f.
If you know the channel number (frequency)
Press the number buttons to enter the channel number of the broadcast you want or your VCR channel number.
4Press 
to jump to “Confirm”, then press 
.
Repeat the procedure above to preset other channels manually.
Label
Assigns a name of your choice, up to five letters or numbers, to the selected channel.
AFT
Allows you to
Audio Filter
Improves the sound for individual channels in the case of distortion in mono broadcasts. Sometimes a
If you do not experience any sound distortion, we recommend that you leave this option set to the factory setting “Off”.
~
• “Audio Filter” is not available when “System” is set to “L”.
Skip
Skips unused analogue channels when you press PROG +/- to select channels. (You can still select a skipped channel using the number buttons.)
Confirm
Saves changes made to the “Manual Programme Preset” settings.