ConditionExplanation/Solution
Tonal balance is not as desired • Depending on the location of objects around this unit, low and/or high frequencies may be affected. Adjust “Bass” and “Treble” settings as preferred (page 41).
Channels
| The desired channel cannot be | • Switch between digital and analogue mode and select the desired digital/ |
| selected | analogue channel. |
|
|
|
| Some channels are blank | • Scrambled/Subscription only channel. Subscribe to the pay TV service. |
|
| • Channel is used only for data (no picture or sound). |
|
| • Contact the broadcaster for transmission details. |
|
|
|
| Digital channels are not | • Contact a local installer to find out if digital transmissions are provided |
| displayed | in your area. |
|
| • Upgrade to a higher gain aerial. |
|
|
|
| Wireless communication |
| |
| Delay pictures | • Wireless communication takes time to establish after turning the power |
|
| on. About 20 seconds are needed to display pictures. Selecting “Quick |
|
| Start” may shorten the waiting time (page 30). |
|
|
|
| “Wireless communication in | • When the wireless communication is disturbed, it takes about 15 seconds |
| progress.” does not disappear, | to display pictures again. “Wireless communication in progress.” is |
| or “Wireless communication | displayed until pictures come back. |
| failed.” is displayed | • Check the installation situation of the monitor and media receiver (page 6). |
|
| • Check whether wireless equipment using the same radio frequency as |
|
| this unit is working near by, or something disturbing wireless |
|
| communication of this unit is close to the unit. In such cases, keep such |
|
| equipment away from the unit or turn off the power of that equipment. |
Noisy or interrupted picture or • Check the installation situation of the monitor and media receiver (page 6).
sound• Pictures may be distorted if somebody walks across between the monitor and media receiver.
•Check whether wireless equipment using the same radio frequency as this unit is working near by, or something disturbing wireless communication of this unit is close to the unit. In such cases, keep such equipment away from the unit or turn off the power of that equipment.
GeneralDistorted picture and/or sound • Keep the unit away from electrical noise sources such as cars, motorcycles,
•When installing optional equipment, leave some space between the optional equipment and the unit.
•Check the aerial/cable connection.
•Keep the aerial/cable TV cable away from other connecting cables.
The unit turns off | • Check if the “Sleep Timer” is activated, or confirm the “Duration” |
automatically (the unit enters | setting of “On Timer Settings” (page 30). |
standby mode) | • If no signal is received and no operation is performed in the TV mode |
| for 10 minutes, the monitor automatically switches to standby mode. |
|
|
The unit turns on | • Check if the “On Timer” is activated (page 30). |
automatically |
|
|
|
Some input sources cannot be | • Select “AV Preset” and cancel “Skip” of the input source (page 32). |
selected |
|
|
|
The remote does not function | • Replace the batteries. |
| • Register the remote to the unit using the / / / / buttons on the |
| front of the media receiver (page 43). |
|
|
A channel cannot be added to | • Up to 999 channels can be stored in the Favourite list. |
the Favourite list |
|
|
|
HDMI equipment does not | • Check that your equipment is “Control for HDMI” compatible |
appear on “HDMI Device List” equipment. | |
|
|
Not all channels are tuned | • Check support web site for cable provide information: |
| |
|
|