Auto Tuning

Do you want to start Auto Tuning?

OKCancel

6Press F/f to select “Antenna” or “Cable”, then press .

If you select “Cable”, the screen for selecting the scan type appears. See “To tune the unit for Cable connection” (page 11).

The unit starts searching for all available digital channels, followed by all available analogue channels. This may take some time, so do not press any buttons on the unit or remote while proceeding.

If a message appears for you to confirm the aerial connection

No digital or analogue channels were found. Check all the aerial/cable connection and then press to start auto- tuning again.

7When the “Programme Sorting” menu appears on the screen, follow the steps of “Programme Sorting” (page 37).

If you do not change the order in which the analogue channels are stored on the unit, press RETURN to go to step 8.

8

Quick Start

Do you want to enable Quick Start?

TV turns on more quickly but standby power

consumption is increased.

YesNo

For details, see page 33.

9

Control for HDMI

Do you want to enable control for compatible

HDMI devices?

Choosing "Yes" will increase standby power consumption.

YesNo

For details, see page 31.

10Press .The unit has now tuned in all the available channels.

~

•When a digital broadcast channel cannot be received, or when selecting a country in which there are no digital broadcasts in step 3, the time must be set after performing step 7.

To tune the unit for Cable connection1Press .2Press F/f to select “Quick Scan” or “Full Scan”, then press .

“Quick Scan” : channels are tuned according to the cable operator information within the broadcast signal. Recommended setting for “Frequency”, “Network ID” and “Symbol Rate” is “Auto”.

This option is recommended for fast tuning when supported by your cable operator.

If the “Quick Scan” does not tune, please use the “Full Scan” method below. “Full Scan” : All available channels are tuned and stored. This procedure may take some time.

This option is recommended when “Quick Scan” is not supported by your cable provider.

For further information about supported cable providers, refer to support web site: http://support.sony-europe.com/TV/ DVBC/

3Press f to select “Start”, then press .

The unit starts searching for channels. Do not press any buttons on the unit or remote.

~

•Some cable providers do not support “Quick Scan”. If no channels are detected using “Quick Scan”, perform “Full Scan”.

Guide up-Start

11 GB