Programme Labels (Analogue mode only)
Assigns a channel name of your choice up to five letters or numbers. The name will be displayed briefly on the screen when the channel is selected. (Names for channels are usually taken automatically from Analogue Text (if available).)
1
2 Press M/m to select the channel you want to name, then press OK.
3 Press M/m/</, to select the desired letter or number (“s” for a blank space), then press OK.
If you input a wrong character
Press M/m/</, to select %/5 and press OK repeatedly until the wrong character is selected. Then, press M/m/</, to select the correct character and press OK.
4
5
Repeat the procedure in step 3 until the name is complete.
Press M/m/</, to select “End”, then press OK.
AV Preset
Assigns a name to any equipment connected to the side and rear sockets. The name will be displayed briefly on the screen when the equipment is selected. You can skip an input source that is not connected to any equipment.
1
2
3
Press OK to select “AV Preset”.
Press M/m to select the desired input source, then press OK. Press M/m to select the desired option below, then press OK.
Option | Description |
|
|
Equipment labels | Uses one of the preset labels to assign a name to connected |
| equipment. |
|
|
Edit | Creates your own label. Follow steps 3 to 5 of “Programme Labels” |
| |
|
|
Skip | Skips an input source that is not connected to any equipment when |
| you press M/m to select the input source. |
|
|
Manual Programme Preset (Analogue mode only)
Before selecting “Label”/“AFT”/“Audio Filter”/“Skip”/“ATT”, press PROG +/- to select the programme number with the channel. You cannot select a programme number that is set to skip (page 32).
1
2
Press OK to select “Manual Programme Preset”.
Press M/m to select one of the following options, then press OK.
30