Problem

v, V, B and b buttons do not work in PAP mode.

Remote control does not function.

The standby indicator on the TV flashes.

The lamp indicator on front of the TV set is lit.

Solution

•PAP navigation is only possible in TV mode, please check that Media Selector is set to TV.

•Be sure you are ponting it towards the remote control receiver (see page 8).

•Check that the Media Selector on the remote control is set to the device you are using (VCR, TV or DVD).

•If the remote control does not operate the VCR or DVD even when the Media Selector has been set correctly. Enter the necessary code set as explained on page 26.

•Replace the batteries.

•Contact your nearest Sony service centre.

• Turn the TV off. Turn the TV on again, if the lamp indicator is still lit then

GB

replace the internal lamp. For details refer to pages 28 and 29.

 

Personal Computer

Problem

If no picture is displayed and the NO SYNC message appears on the screen.

Some picture lines are not correctly displayed.

Blurred letters or vertical lines or shade or noise is visible in detailed patterns.

The Startup or the Setting screens of the Personal Computer cannot be displayed.

Solution

•Check that the video signal cable is properly connected and all plugs are firmly seated in their sockets.

•Check that the 15-Dsub video input connector’s pins are not bent or pushed in.

Personal Computer output format

•Check that the output signal format of the Personal computer is set to the corresponding format for the television. In case it is not, adjust the resolution and refresh rate to the corresponding signal (refer to page 31).

Problems caused by the connected computer

•The computer is in power saving mode. Try pressing any key on the computer keyboard.

•Check that the computer’s power is "on".

•Check that the computer’s keyboard is properly connected.

•Check that the graphic board is completely seated in the proper bus slot.

•In case of a notebook PC, check that the monitor signal is set to the external output, and the signal is correctly output to the television.

•Using the menu system, select the "Picture Adjustment" menu and adjust the "Lines Correction" option between -20 and +20 (see page 13).

•Small letters, check or mesh patterns cannot be accurately displayed. In this case, increase the size of the fonts and/or reduce the mesh pattern brightness.

•Depending on the PC, the Startup or Setting screens may not be displayed due to the output format of the image. These screens can be displayed on the monitor of the Personal Computer.

•If you continue to experience problems, have your TV serviced by qualified personnel.

•Never open the casing yourself.

Additional Information 33