V. Center Adjustment (VPOS)
Perform this adjustment after performing H. Frequency (Free Run) Check.
1.Input a crosshatch signal.
2.Activate the Service Adjustment Mode.
3.Select the VPOS item with 
and 
.
4.Adjust value of VPOS with 
and 
for the best vertical center.
5.Press 
then 
to save into the memory.
H. Center Adjustment (HPOS)
Perform this adjustment after performing H. Frequency (Free Run) Check.
1.Input a crosshatch signal.
2.Activate the Service Adjustment Mode.
3.Select the HPOS item with 
and 
.
4.Adjust the value of HPOS with 
and 
for the best horizontal center.
5.Press 
then 
to save into the memory.
H. Size Adjustment (HSIZ)
1.Input a monoscope signal.
2.Activate the Service Adjustment Mode.
3.Select HSIZ with 
and 
.
4.Adjust with 
and 
for the best horizontal size.
5.Press 
then 
to save into the memory.
V. Linearity (VLIN), V. Correction (VSCO),
Pin Amp (PAMP), and Horizontal Trapezoid
(TRAP) Adjustments
1.Input a crosshatch signal.
2.Activate the Service Adjustment Mode.
3.Select VLIN, VSCO, PAMP, and PPHA with with 
and 
.
4.Adjust with 
and 
for the best horizontal size.
5.Press 
then 
to save into the memory.
KV-27FV16/29FV16/29FV16C/32FS12/32FS16
V LINEARITY (VLIN)
V CORRECTION (VSCO)
PIN AMP (PAMP)
HORIZONTAL TRAPEZOID (TRAP)
V. Angle (VANG), V. Bow (VBOW), Upper pin (UPIN) and Low Pin (LPIN) Adjustments
1.Input a crosshatch signal.
2.Activate the Service Adjustment Mode.
3.Select VANG, VBOW, UPIN, and LPIN with 
and 
.
4.Adjust with 
and 
for the best picture.
5.Press 
then 
to save into the memory.
V ANGLE (VANG)
V BOW (VBOW)
UPPER PIN (UPIN)
LOW PIN (LPIN)
Service Adjustment Mode Memory
1.Change the value of the DCOL item to “1”.
2.After completing all adjustments, press 
then 
.
Read From Memory
SERVICE | READ | Green |
0
Red
ENTER
— 27 —
