4 Press PRESET + or – and select the preset number you want.

Preset number

TUNED

 

PRESET EQ

 

FLAT ROCK POPS JAZZ

MHz

5 Press MEMORY.

The station is stored.

6 Repeat steps 1 to 5 to store other stations.

To tune in a station with a weak signal

Press )± or -0 repeatedly to tune in the station.

To change the preset number

Start again from step 1.

To change the AM tuning interval (except for North American, Mexican, Australian and Middle Eastern models)

The AM tuning interval is factory-preset to 9 kHz (10 kHz in some areas). To change the AM tuning interval, turn off the power and change the position of the AM TUNING STEP switch on the rear panel to 10 kHz (or 9 kHz). Then turn the power back on. To reset the interval, repeat the same procedure.

Tip

The preset stations are retained for a week even if you pull out the AC power cord or if a power failure occurs.

Connectingoptional AVcomponentsand outdoorantennas

Connecting a turntable

To enhance your system, you can connect a turntable. Refer to the instructions of each component.

Make sure to match the colour of the plugs and the connectors.

To the audio output of a turn table.

To listen to the sound of a turntable

Press PHONO.

“Phono” appears in the display.

Tip

You can record the turntable sound.

continued

7

LBT-G1/LBT-G1300. 3-859-546-53. EN

Page 7
Image 7
Sony LBT-G1300 manual Connectingoptional AVcomponentsand outdoorantennas, To tune in a station with a weak signal